This is a working overview of electrospray ionisation, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2026-01-30 and is reviewed periodically as new material appears.
Material sold for research use varies widely in documented quality. A useful verification package includes a certificate of analysis that states peptide content rather than only net weight, the chromatographic method and column used, and a mass spectrum consistent with the expected mass. Independent testing by a third-party laboratory is occasionally reported. Statements of identity resting only on a supplier label provide little assurance, and the gap between nominal mass and actual peptide content can be substantial once counterions and residual water are counted.
Peptides of this size are generally stable as dry solids but degrade in solution over time. The principal routes are hydrolysis of the peptide backbone and oxidation, with hydrolysis favoured by elevated temperature and extreme pH. Aqueous solutions held at room temperature can show measurable loss of purity within days, while frozen aliquots are considerably more durable. Because the sequence contains neither cysteine nor methionine, oxidation is less of a concern than for many other peptides, but pH control during handling still matters.
Typical storage for the lyophilized powder is −20 °C or lower, in a sealed container protected from light and moisture. Hygroscopic material should be allowed to equilibrate to room temperature before the vial is opened, which limits condensation on the contents. Working solutions are commonly divided into single-use aliquots and frozen to avoid repeated freeze-thaw cycles. Dilute solutions are more prone to adsorption onto plastic surfaces and to loss during filtration, so procedures that minimize transfers and use low-binding labware are preferable.
Chemically, the molecule consists of four amino acid residues joined by three peptide bonds, with a free N-terminal amino group and a free C-terminal carboxyl group. Its molecular formula is C14H22N4O9, and its monoisotopic mass is approximately 390 daltons. The acidic glutamate and aspartate side chains give the peptide a net negative charge near neutral pH, a property that shapes its chromatographic behaviour and solubility profile. No disulfide bridges or other post-translational modifications are present, so the primary sequence alone defines the structure.
Most experimental work has been carried out in cell culture and animal models. Several reports describe changes in telomerase activity and proliferation in cultured cells, while rodent studies have examined lifespan, melatonin rhythm and reproductive endpoints. Human data remain limited, and much of the published clinical material consists of small trials with incomplete reporting of methods and controls. Whether the cell and animal findings translate into measurable effects in people is an open question, and the mechanistic basis of the reported telomerase changes is not fully established.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilized solid |
| Solubility | Freely soluble in water | Also dissolves in polar organic solvents |
| Typical storage temperature | −20 °C or below | Sealed, desiccated, protected from light |
| Primary purity assay | Reversed-phase HPLC | Ultraviolet detection near 214 nm |
| Identity confirmation | Mass spectrometry | Electrospray ionization commonly used |
Purity assessment of peptide reagents normally relies on reversed-phase high-performance liquid chromatography. A gradient of acetonitrile in water with trifluoroacetic acid, paired with a C18 stationary phase, separates the target tetrapeptide from truncated sequences and deletion analogues. Detection at 214 nanometres exploits absorbance of the peptide backbone, since the molecule contains no aromatic residue. Results are expressed as a percentage of total peak area. Values above ninety-five percent are typical for research-grade material, although reporting conventions vary between suppliers.
Identity confirmation uses mass spectrometry, usually electrospray ionisation in positive mode or matrix-assisted laser desorption. The protonated free peptide produces a signal near three hundred and ninety-one daltons, while salt adducts shift that value slightly. Tandem mass spectrometry or amino acid analysis supplies sequence-level confirmation, which a single mass measurement cannot. Peptides containing aspartate can cyclise into succinimide intermediates that hydrolyse to isoaspartate isomers of identical mass. Because those isomers are difficult to separate chromatographically, identity and purity results carry more weight when interpreted together.
Storage practice centres on limiting moisture, oxygen, and repeated temperature cycling. Freeze-dried powder is generally held desiccated at minus twenty degrees Celsius or colder and protected from light. Reconstituted solutions are markedly less stable, and the aspartate-glycine junction is prone to succinimide formation at neutral to mildly alkaline pH. Portioning material into single-use aliquots reduces degradation compared with repeated freeze-thaw cycles. Stability data specific to this tetrapeptide remain scarce, so most handling guidance is extrapolated from general peptide chemistry rather than measured directly.
Epitalon is a synthetic tetrapeptide with the residue sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. Its monoisotopic mass is approximately 390.35 daltons, and it is usually supplied as a lyophilised trifluoroacetate or acetate salt. The compound was derived from a pineal gland extract called epithalamin, a heterogeneous preparation investigated in the former Soviet Union. Researchers associated with the Saint Petersburg Institute of Bioregulation and Gerontology described the tetrapeptide as a constituent fragment of that extract. Commercial material is offered as a laboratory reagent rather than as a finished pharmaceutical product.
Literature searches for this compound must account for several spelling variants. Indexing databases contain epitalon, epithalon, epithalone, and AEDG, and relevant records are scattered across Russian-language and English-language journals that do not consistently cross-cite. Early publications describe the parent extract as a mixture of many peptides, whereas later work addresses the single synthetic tetrapeptide. That shift in nomenclature complicates comparison between studies, because extract data and tetrapeptide data are sometimes cited interchangeably. A search strategy omitting the alternate spellings will return an incomplete set of references.
Reported biological findings come mainly from cell culture and rodent experiments. Those studies describe changes in telomerase catalytic subunit expression, melatonin rhythm amplitude, and antioxidant enzyme activity after peptide exposure. Human data are sparse and consist of small trials with limited blinding and inconsistent endpoints. The proposed mechanisms remain hypotheses rather than established facts, and there is no consensus on whether effects observed in animals carry over to people. Independent replication outside the original research groups is limited, which is a recognised gap in the published literature.
Verification of a sample usually begins with reversed-phase high-performance liquid chromatography, which resolves the peptide from truncated sequences and other impurities and expresses purity as a percentage of total peak area. Mass spectrometry by electrospray ionisation or matrix-assisted laser desorption supplies an independent check, because the measured mass can be compared against the theoretical value for AEDG. Amino acid analysis or tandem mass spectrometry sequencing can confirm residue order. Each of these methods answers a different question: a purity figure does not establish identity, and an identity match does not establish how much of the material is intact peptide.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
=== Mauritius === Mauritius is dependent on oil imports for generating power, and, after a shipment of oil had not arrived as scheduled on 30 March, only 21 days of stock remained in the country. The government arranged for more expensive alternative fuel to be shipped from Singapore, and imposed restrictions to reduce wastage of fuel.
=== Optic disc drusen === NAION in patients with optic disc drusen has unique characteristics: earlier onset, history of transient visual disturbances, and generally better visual outcomes. Mechanical pressure from drusen on blood vessels near the optic nerve may contribute to NAION development in these individuals.
==== Silver alloy – synergistic oxidation of carbon monoxide ==== Au-Ag alloy nanoparticles have been shown to have a synergistic effect on the oxidation of carbon monoxide (CO). On its own, each pure-metal nanoparticle shows very poor catalytic activity for CO oxidation; together, the catalytic properties are greatly enhanced. It is proposed that the gold acts as a strong binding agent for the oxygen atom and the silver serves as a strong oxidizing catalyst, although the exact mechanism is still not completely understood. When synthesized in an Au/Ag ratio from 3:1 to 10:1, the alloyed nanoparticles showed complete conversion when 1% CO was fed in air at ambient temperature. The size of the alloyed particles did not play a big role in the catalytic ability. It is well known that gold nanoparticles only show catalytic properties for CO when they are ~3 nm in size, but alloyed particles up to 30 nm demonstrated excellent catalytic activity – catalytic activity better than that of gold nanoparticles on active support such as TiO2, Fe2O3, etc.
Only two of the Russian frigates provided important services in the Caribbean in defense of the island of Cuba, although they only made the one-way trip, they got lost, sunk when they arrived in Havana.
Sources: en.wikipedia.org
A torsion angle, found in stereochemistry, is a particular example of a dihedral angle describing the geometric relation of two parts of a molecule joined by a chemical bond. Every set of three non-colinear atoms of a molecule defines a half-plane. As explained above, when two such half-planes intersect (i.e., a set of four consecutively-bonded atoms), the angle between them is a dihedral angle. Dihedral angles are used to specify the molecular conformation. Stereochemical arrangements corresponding to angles between 0° and ±90° are called syn (s), those corresponding to angles between ±90° and 180° anti (a). Similarly, arrangements corresponding to angles between 30° and 150° or between −30° and −150° are called clinal (c) and those between 0° and ±30° or ±150° and 180° are called periplanar (p). The two types of terms can be combined so as to define four ranges of angle; 0° to ±30° synperiplanar (sp); 30° to 90° and −30° to −90° synclinal (sc); 90° to 150° and −90° to −150° anticlinal (ac); ±150° to 180° antiperiplanar (ap). The synperiplanar conformation is also known as the syn- or cis-conformation; antiperiplanar as anti or trans; and synclinal as gauche or skew. For example, with n-butane two planes can be specified in terms of the two central carbon atoms and either of the methyl carbon atoms. The syn-conformation shown above, with a dihedral angle of 60° is less stable than the anti-conformation with a dihedral angle of 180°. For macromolecular usage the symbols T, C, G+, G−, A+ and A− are recommended (ap, sp, +sc, −sc, +ac and −ac respectively).
=== Legal status === In November 2024, the Committee for Medicinal Products for Human Use of the European Medicines Agency adopted a positive opinion, recommending the granting of a conditional marketing authorization for the medicinal product Augtyro, intended for the treatment of people whose solid tumors have a neurotrophic tyrosine receptor kinase (NTRK) gene fusion, or people with ROS1-positive advanced non-small cell lung cancer (NSCLC). The applicant for this medicinal product is Bristol-Myers Squibb Pharma EEIG. Repotrectinib was authorized for medical use in the European Union in January 2025.
=== Business === Protein Capture Science is a biotech start-up company commercializing a self-removing affinity tag technology for research and large-scale purifications of proteins. Wood and Izabela Gierach are co-founders of the company, based in Columbus, Ohio. The first line of the iCapTag products for protein purification was showcased in the Industry Innovators 2021-2022 Issue of the journal BioProcess International. Protein Capture Science was recently awarded several grants and funding, including highly competitive The Ohio Third Frontier Technology Validation and Start-Up Fund and the Concept Fund for extraordinary technologies by the Department of Development, State of Ohio.
Sources: en.wikipedia.org
The powder is normally kept at −20 °C or below in a sealed, moisture-protected container. Letting the vial reach room temperature before opening helps prevent condensation on the contents.
Reversed-phase HPLC with ultraviolet detection is the usual approach, often paired with mass spectrometry. Together the two methods address both chromatographic purity and molecular identity.
Differences arise from the analytical method, the detection wavelength, and whether the number refers to the peptide or to total powder mass. Counterion and water content can lower the actual peptide fraction considerably.
It is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, often abbreviated AEDG. The molecule is linear and contains no modified residues, so it is fully described by its sequence.