A practical reference on tetrapeptide: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2025-10-13. Anything still debated is marked as such rather than presented as settled.
Verification of a sample usually begins with reversed-phase high-performance liquid chromatography, which resolves the peptide from truncated sequences and other impurities and expresses purity as a percentage of total peak area. Mass spectrometry by electrospray ionisation or matrix-assisted laser desorption supplies an independent check, because the measured mass can be compared against the theoretical value for AEDG. Amino acid analysis or tandem mass spectrometry sequencing can confirm residue order. Each of these methods answers a different question: a purity figure does not establish identity, and an identity match does not establish how much of the material is intact peptide.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
Epitalon is a synthetic linear tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and the calculated mass is approximately 390.35 g/mol. The compound is made by solid-phase peptide synthesis rather than extracted from tissue, although early work described it as a short fragment of a peptide fraction obtained from bovine pineal extract. In the research literature the spelling epitalon and the variant epithalone both appear, while AEDG is the standard code used in peptide nomenclature.
Several names circulate for the same molecule, including epitalon, epithalone, epithalamin tetrapeptide, and the sequence code AEDG. A CAS registry number, 307297-39-8, is commonly cited for it, though catalogue entries should be checked against supplier documentation because mislabelled records occur. In its usual form the peptide carries free amino and carboxyl termini and is neither glycosylated nor lipidated. Researchers distinguish the defined tetrapeptide from epithalamin itself, a crude pineal preparation containing many peptides that is not chemically characterised.
| Property | Value | Notes |
|---|---|---|
| Identity confirmation | Electrospray or MALDI mass spectrometry | Observed mass compared with theoretical 390.35 Da |
| Purity specification | 95 percent or greater by RP-HPLC | Common convention for research-grade peptide |
| Counter-ion | Acetate or trifluoroacetate | Affects net peptide content of a weighed sample |
| Solution storage | −80 °C as single-use aliquots | Repeated freeze–thaw cycles accelerate loss |
| Main degradation route | Aspartimide formation at Asp-Gly | Produces isoaspartate and related species |
Lyophilised epitalon is generally held at minus twenty degrees Celsius in a sealed container kept dry and dark. Cooler conditions are sometimes recommended for long-term archives. The solid takes up moisture readily enough that repeated opening of a vial introduces water, so dividing a batch into smaller portions before storage lowers degradation risk. Aqueous solutions are less durable than the dry powder and are usually prepared shortly before use, then kept cold and shielded from light to slow hydrolysis and oxidation.
Verification of research-grade material involves comparing a supplier chromatogram against an in-house reference, checking the observed mass against the calculated value, and where possible confirming residue order by tandem mass spectrometry or enzymatic peptide mapping. Purity claims should be read alongside the method used to obtain them, because detection wavelength and integration settings alter the result. Batch-specific data, rather than a generic grade statement, is the informative part of a certificate.
Discussions in the literature often conflate three distinct entities: the pineal extract epithalamin, the isolated tetrapeptide AEDG, and commercial preparations sold under similar names. Reviews citing older Russian-language studies sometimes omit detail on purity, route of administration and control groups, which makes cross-study comparison difficult. Researchers working with the compound generally note the need for independent replication, standardized enzyme assays, and clearer reporting of peptide identity. These caveats are relevant when weighing claims that appear in secondary sources rather than in primary reports.
（TG:@pojiaai）Epitalon is a synthetic linear tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. It emerged from work on epithalamin, a peptide fraction prepared from bovine pineal tissue, and was designed as a short, chemically defined analogue of that extract. Early publications came mainly from Russian laboratories studying pineal peptides and aging-related endpoints. The compound appears in the literature under several spellings, including epithalon and epithalone, which complicates systematic searching. Its small size makes solid-phase assembly and routine analytical characterization straightforward.
Chemically, the molecule consists of four amino acid residues joined by three peptide bonds, with a free N-terminal amino group and a free C-terminal carboxyl group. Its molecular formula is C14H22N4O9, and its monoisotopic mass is approximately 390 daltons. The acidic glutamate and aspartate side chains give the peptide a net negative charge near neutral pH, a property that shapes its chromatographic behaviour and solubility profile. No disulfide bridges or other post-translational modifications are present, so the primary sequence alone defines the structure.
==== Metals as catalytic sites ==== The metals in the MOF structure often act as Lewis acids. The metals in MOFs often coordinate to labile solvent molecules or counter ions which can be removed after activation of the framework. The Lewis acidic nature of such unsaturated metal centers can activate the coordinated organic substrates for subsequent organic transformations. The use of unsaturated metal centers was demonstrated in the cyanosilylation of aldehydes and imines by Makoto Fujita and coworkers in 2004. They reported MOF of composition {[Cd(4,4′-bpy)2(H2O)2] • (NO3)2 • 4H2O} which was obtained by treating linear bridging ligand 4,4′-bipyridine (bpy) with Cd(NO3)2. The Cd(II) centers in this MOF possess a distorted octahedral geometry having four pyridines in the equatorial positions, and two water molecules in the axial positions to form a two-dimensional infinite network. On activation, two water molecules were removed leaving the metal centers unsaturated and Lewis acidic. The Lewis acidic character of metal center was tested on cyanosilylation reactions of imine where the imine gets attached to the Lewis-acidic metal centre resulting in higher electrophilicity of imines. For the cyanosilylation of imines, most of the reactions were complete within 1 h affording aminonitriles in quantitative yield. Kaskel and coworkers carried out similar cyanosilylation reactions with coordinatively unsaturated metals in three-dimensional (3D) MOFs as heterogeneous catalysts.
== Isolation == The isolation of tryptophan was first reported by Frederick Hopkins in 1901. Hopkins recovered tryptophan from hydrolysed casein, recovering 4–8 g of tryptophan from 600 g of crude casein.
Any floating object displaces its own weight of fluid. In other words, for an object floating on a liquid surface (like a boat) or floating submerged in a fluid (like a submarine in water or dirigible in air) the weight of the displaced fluid equals the weight of the object. Thus, only in the special case of floating does the buoyant force acting on an object equal the objects weight. Consider a 1-ton block of solid iron. As iron is nearly eight times as dense as water, it displaces only 1/8 ton of water when submerged, which is not enough to keep it afloat. Suppose the same iron block is reshaped into a bowl. It still weighs 1 ton, but when it is put in water, it displaces a greater volume of water than when it was a block. The deeper the iron bowl is immersed, the more water it displaces, and the greater the buoyant force acting on it. When the buoyant force equals 1 ton, it will sink no farther. When any boat displaces a weight of water equal to its own weight, it floats. This is often called the "principle of flotation": A floating object displaces a weight of fluid equal to its own weight. Every ship, submarine, and dirigible must be designed to displace a weight of fluid at least equal to its own weight. A 10,000-ton ship's hull must be built wide enough, long enough and deep enough to displace 10,000 tons of water and still have some hull above the water to prevent it from sinking. It needs extra hull to fight waves that would otherwise fill it and, by increasing its mass, cause it to submerge.
Sources: en.wikipedia.org
Polystyrene foams are 95–98% air. Polystyrene foams are good thermal insulators and are therefore often used as building insulation materials, such as in insulating concrete forms and structural insulated panel building systems. Grey polystyrene foam, incorporating graphite, has superior insulation properties. Carl Munters and John Gudbrand Tandberg of Sweden received a US patent for polystyrene foam as an insulation product in 1935 (USA patent number 2,023,204). PS foams also exhibit good damping properties, therefore it is used widely in packaging. The trademark Styrofoam by Dow Chemical Company is informally used (mainly US & Canada) for all foamed polystyrene products, although strictly it should only be used for "extruded closed-cell" polystyrene foams made by Dow Chemicals. Foams are also used for non-weight-bearing architectural structures (such as ornamental pillars).
=== Cardiovascular === MMP9 levels increase with the progression of idiopathic atrial fibrillation. MMP9 has been found to be associated with the development of aortic aneurysms, and its disruption prevents the development of aortic aneurysms. Doxycycline suppresses the growth of aortic aneurysms in animal models through its inhibition of MMP9 reduces aortic inflammation in humans.
Collagen alpha-1(XIX) chain is a protein that in humans is encoded by the COL19A1 gene. This gene encodes the alpha chain of type XIX collagen, a member of the FACIT collagen family (fibril-associated collagens with interrupted helices). Although the function of this collagen is not known, other members of this collagen family are found in association with fibril-forming collagens such as type I and II, and serve to maintain the integrity of the extracellular matrix. The transcript produced from this gene has an unusually large 3' UTR which has not been completely sequenced.
== Structure == The cornea has unmyelinated nerve endings sensitive to touch, temperature and chemicals; a touch of the cornea causes an involuntary reflex to close the eyelid. Because transparency is of prime importance, the healthy cornea does not have or need blood vessels within it. Instead, oxygen dissolves in tears and then diffuses throughout the cornea to keep it healthy. A 2023 hypothesis by Mazyar Yazdani from Oslo University Hospital proposed that the tear film lipid layer may contribute to corneal oxygen supply. Similarly, nutrients are transported via diffusion from the tear fluid through the outside surface and the aqueous humour through the inside surface. Nutrients also reach the cornea via neurotrophins supplied by the nerves of the cornea. In humans, the cornea has a diameter of about 11.5 mm and a thickness of 0.5–0.6 mm in the center and 0.6–0.8 mm at the periphery. Transparency, avascularity, the presence of immature resident immune cells, and immunologic privilege makes the cornea a very special tissue. The most abundant soluble protein in mammalian cornea is albumin. The human cornea borders with the sclera at the corneal limbus. In lampreys, the cornea is solely an extension of the sclera, and is separate from the skin above it, but in more advanced vertebrates it is always fused with the skin to form a single structure, albeit one composed of multiple layers. In fish, and aquatic vertebrates in general, the cornea plays no role in focusing light, since it has virtually the same refractive index as water.
Sources: en.wikipedia.org
Mass spectrometry provides the identity check, because the observed mass is compared with the theoretical mass of the AEDG sequence. Chromatography separates and quantifies impurities but does not by itself prove which peptide is present. The two techniques are normally used together.
Yes. Trifluoroacetate and acetate ions remain associated with the peptide after purification, so a weighed quantity of powder contains less peptide than the nominal mass suggests. Certificates that report net peptide content rather than raw weight are more directly comparable between suppliers.
Dilute aqueous solutions are less stable than the dry powder and are usually aliquoted and frozen to avoid repeated freeze–thaw cycles. Lyophilised material is best stored desiccated at −20 °C, protected from light. Working solutions are typically prepared fresh from a frozen aliquot.
It is a synthetic tetrapeptide. Its sequence was derived from research on peptide fractions of bovine pineal extract, and the intact AEDG sequence has not been demonstrated as an abundant free peptide in human tissue.